www.rgc.ro Web analytics

Jump to content

Ajutor-Sincronizare Procesor Analog La Cubase7!


Recommended Posts

Buna seara!

Va rog sa ma ajutati pentru a-mi sincroniza procesorul de voce ( MX 200 Lexicon ) cu soft-ul ( Cubase 7 ) . 

        Mentionez faptul ca in manualul procesorului imi spune ca , pot folosi  acelasi driver de pe sit-ul celor de la Lexicon atat sa-mi editez libraria de efecte cat si ca VST in soft.Problema care este , dupa ce am instalat driverul device-ului respectiv am incercat sa-l inserez ca si VST , numai ca mi-a dat o eroare  : 1. " MX-Edit was unable to locate a device.This  may happen for any of the following reasons : 

 - the device is not connected to your computer ;

 - MX- Edit is already running ( try opening presets from within the application ) ;

 - another application is already using the device's MIDI ports ;

 - the USB MIDI drivers have not been properly installed . "  

        Bun , dupa toata chestia asta am incercat sa-l fac manual din soft ( Cubase ) : - din Device - Plug-in Information - upgrade plug-in's , am reusit intr-un final sa mi-l vada acolo insa , atunci cand dau sa inserez pe un track VST-ul imi spune alta eroare : 2." All wiews must be created on the same thread "   . 

        Dupa toate chestile de genu am recitit iar manualul procesorului si zic ei acolo ca in cazul in care primesc eroare de genu ( 1 )  ,  sa fac pasii :

 " If you see this message , the MX 200 is either disconnected or its USB MIDI ports are in use by an application. Some hosts , such as Cubase , may automatically open the MX200's MIDI ports by default . In this case , you will need to deselect or disable the port named " Lexicon MX200 Control " in the application's MIDI Devices setup "    , am facut si lucru asta asa cum zic ei insa fara nici un fel de rezultat pozitiv .

        Va rog mult sa ma ajutati si sa-mi spuneti ce trebuie sa fac sau cum trebuie sa fac pas cu pas....va multumesc !!!                                                                                                                                                         

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

"This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies.